BMXXG - 4701, TRAFFIC MARKING OIL BASE
- MSDS: BMXXG
- Manufacturer: EVR GARD COATINGS CO
- Product Name: 4701, TRAFFIC MARKING OIL BASE
- National Stock Number: 8010-00N028437
Product Identification
Product ID:4701, TRAFFIC MARKING OIL BASE
MSDS Date:10/05/1989
FSC:8010
NIIN:00N028437
MSDS Number: BMXXG
Responsible Party
PARAMOUNT, CA 90723
US
Emergency Phone: 213-531-0131
Info Phone: 213-531-0131
Cage: 5G582
Contractor
Telephone: 310-531-0131
Cage: 5G582
Ingredients
5 @ 77F.
CAS: 64742-88-7
Fraction By Weight: 4.96%
OSHA PEL 125 PPM (MFR)
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: IRRIT OF NOSE, THROAT AND
EYES, DIZZ, WEAK, FATIGUE, NAUS, HDCH. SYMPTOMS DISAPPEAR WHEN
EXPOSURE CEASES. EYE OR SKIN CONT MAY CAUSE IRRIT. REPORTS HAVE
SHOWN THAT RPTD AND PRLNGD OCCUPATI ONAL OVEREXP TO SOLVENTS CAN
CAUSE PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:INHAL: EXCESSIVE INHAL OF VAPS MAY RSLT IN DIZZ
& HDCH. UNCON IN EXTREME CASES. SKIN/EYE: IRRITANT. AFFECTED AREA
WILL SHOW SIGNS OF REDNESS AND RASH IF NOT WASHED WITH SOAPY H*2O
IMMED. INGEST: IRRIT OF RESP TRACT CHARACT BY HDCH, DIZZ, STAG,
CONFUSION & UNCON & COMA IN EXTREME CASES.
Medical Cond Aggravated by Exposure:PROLONGED OR REPEATED CONTACT MAY
CAUSE DERMATITIS.
First Aid
First Aid:INHALATION: REMOVE PATIENT TO FRESH AIR. EYE: FLUSH WITH
PLENTY OF WATER FOR AT LEAST 15 MINUTES. SKIN: REMOVE SOAKED
CLOTHING AND WASH SKIN WITH SOAPY WATER THOROUGHLY. INGESTION: DO
NOT INDUCE VOMIT ING. CALL PHYSICIAN IMMEDIATELY.
Fire Fighting
Flash Point:105F,41C
Lower Limits:1.0%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT
EQUIP.FIGHT AS VOLATILE FIRE.CLSD CNTNRS MAY EXPLO WHEN EXPOS TO
EXTREME HEAT. KEEP AWAY FROM AREAS EXPOS TO FIRE.
Unusual Fire/Explosion Hazard:AVOID APPLIC IN AREAS OF PILOT LIGHTS,
SPARKS OR OTHER IGNIT SOURCES AS VAPS MAY ACCUMULATE ON FLOOR &
IGNITE. KEEP CNTNRS CLSD TIGHTLY & STORE IN (SUPP DATA)
Accidental Release
Spill Release Procedures:ABSORB SPILLED MATERIAL WITH ABSORBENTS, SUCH
AS SAWDUST, CLAYS, ETC., AND FLUSH SPILL AREA WITH LOTS OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT STORE NEAR OPEN FLAME OR
SOURCES OF IGNIT. DO NOT STORE IN HIGH TEMP STORAGE. IN CASE OF
FIRE, REMOVE CLSD CNTNRS FROM AREAS EXPOS TO FIRE.
Other Precautions:EMPTY CONTAINERS USUALLY STILL HOLD RESIDUES OF
MATERIAL AND VAPORS. THESE MUST BE CONSIDERED HAZARDOUS AND
DISPOSED OF IN ACCORDANCE WITH PROPER HANDLING PROCEDURES
PRESCRIBED FOR HAZARDOUS CHEMICALS .
Exposure Controls
Respiratory Protection:THE USE OF NIOSH/MSHA APPRVD RESP IS RECOMMENDED
WHEN USING SOLVENT BASED COATINGS. WHEN LEVEL OF SOLVENT VAPS IS
NOT KNOWN OR EXCEEDS LEVEL AT WHICH REGULAR RESP ARE EFFECTIVE, USE
OF NIOSH/MSHA APPR VD RESP SUCH AS TC-19C IS HIGHLY RECOM.
Ventilation:BE SURE TO PROVIDE ADEQ VENT IN ALL WORKING AREAS AT ALL
TIMES. SERIOUS HLTH PROBLEMS COULD RSLT FROM RPTD/PRLNGD EXPOS.
Protective Gloves:NEOPRENE, BUNA N GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:STANDARD HYGIENE PRACTICES MUST BE OBSERVED
WHEN HANDLING THIS PRODUCT AND ALL CHEMICALS.
Supplemental Safety and Health
EXPLO HAZ: COOL PLACE WHEN NOT IN USE.
Chemical Properties
HCC:F4
Vapor Pres:INGREDIENT
Vapor Density:HVR/AIR
Spec Gravity:1.5 (H*2O=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NOT SOLUBLE
Appearance and Odor:PAINT-PAINT THINNER ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALIS. LONG TERM CONTACT WITH WATER.
Stability Condition to Avoid:OPEN FLAMES, WELDING ARCS OR OTHER HIGH
TEMPERATURE SOURCES WHICH INDUCE THERMAL DECOMPOSITION AND FIRE.
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD CARBON
DIOXIDE AND/OR CARBON MONOXIDE.
Disposal
Waste Disposal Methods:DISPOSE OF ALL WASTES, INCLUDING ABSORBENTS USED
TO CLEAN UP SPILLS INTO 55-GAL METAL CONTAINERS AND DISPOSE IN
APPROVED DUMPSITE IN ACCORDANCE WITH PRESCRIBED FEDERAL, STATE AND
LOCAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.